Setting Network Interface Parameters - Kyocera FS-1028MFP Setup Manual

Setting Network Interface Parameters

10
11
12
SETUP GUIDE
This machine supports TCP/IP and TCP/IP (IPv6) protocols. IP is an abbreviation for
Internet Protocol. This machine routinely uses the TCP/IP (IPv4) protocol, but
provides a separate setting for the next generation IP, IPv6. Configure the printer's
network parameters as appropriate for your PC and your network environment.
IMPORTANT: Check with your network administrator when selecting the network
setting. After all network related settings have been done, turn the machine Off and
On again.
TCP/IP (Enable/Disable TCP/IP)
This selects the settings for TCP/IP.
1
Press [System Menu/Counter]. The Sys. Menu/Count. screen appears.
2
Press or to select System.
3
Enter the user name and password to log in.
NOTE:
The default settings of user name and password are both 2800.
4
Press [OK]. The System screen appears.
5
Press or to select Network Setting.
6
Press [OK]. The Network Setting screen appears.
7
Press or to select TCP/IP Setting.
8
Press [OK]. The TCP/IP Setting screen appears.
9
Press or to select TCP/IP.
Press [OK]. The TCP/IP screen appears.
Press or to select whether TCP/IP is enabled.
Press [OK]. The TCP/IP is set and the TCP/IP Setting menu reappears.
IPv4 Settings (TCP/IP IPv4 settings)
This selects the settings for TCP/IP (IPv4).
1
In the TCP/IP Setting menu, press
2
Press [OK]. The IPv4 Setting menu screen appears.
The options available in the TCP/IP (IPv4) settings are as follows:
or to select IPv4 Setting.
Panel Setup
13