Rotating Input Select Switches - Denon DN-X300 Operating Instructions Manual

ENGLISH
6

ROTATING INPUT SELECT SWITCHES

1. Disconnect the power.
2. Remove knobs from the top panel.
3. Remove the 6 screws attaching the top panel.
4. Remove the 2 screws attaching the switch unit.
5. Rotate the switch unit to the desired location.
6. Reinstall the 2 screws holding the switch unit.
7. Reinstall the top panel and reattach knobs.
10
NOTE:
• Only the knob for CUE SELECT is different.
Switch unit
About the Cables
(For RCA in/out jack)
Cable 1
(For SEND/RETURN)
Unbalanced (1/4" TS)
Cable 2
(For BALANCED MASTER OUT)
Balanced (1/4" TRS)
Cable 3
Sleeve=GND
Ring=Cold
Tip=Hot
(For MIC)
Balanced (1/4" TRS)
Cable 4
Sleeve=GND
Ring=Cold
Tip=Hot
(For BALANCED MASTER OUT)
2=Hot 1=GND
Balanced
Cable 5
XLR3-12C
3=Cold
(For MIC EFFECT LOOP)
Adaptor
R=Ring
Cable 6
L=Tip
RCA pin plug
Unbalanced
Unbalanced (1/4" TS)
Balanced (1/4" TRS)
Sleeve=GND
Ring=Cold
Tip=Hot
1=GND
Balanced
2=Hot
XLR3-11C
3=Cold
Balanced (1/4" TRS)
Sleeve=GND
Ring=Cold
Tip=Hot
Balanced (1/4" TRS)
Sleeve=GND
Ring=R
Tip=L