Connections - Denon DN-X300 Operating Instructions Manual

3

CONNECTIONS

Refer to the connection diagram below.
1. Make certain AC power is off while making
connections.
2. Quality cables make a big difference in fidelity and
punch. Use high-quality, audio cables.
3. Do not use excessively long cables. Be sure plugs
and jacks are securely fastened. Loose connections
cause hum, noise, or intermittents that could
damage your speakers.
4. Connect all stereo input sources. Then connect any
effects into the stereo effect, if used. Connect your
microphone(s) and monitor headphones. Make sure
all faders are at "zero" and the unit is off. Take care
to connect only one cable at a time. pay attention to
L and R position of jacks, on both the DN-X300 and
outboard gear.
5. Connect the stereo outputs to the power
amplifier(s) and/or tape deck(s) and/or MD
recorder(s) and/or CD recorder(s). Plug the DN-X300
into AC power outlet.
NOTE:
Always switch on your audio input sources such as
CD players first, then your mixer, and finally any
amplifiers. When turning off, always reverse this
operation by turning off amplifiers, then your mixer,
and then input units.
Main balanced power amplifier
DN-X300
AA-26 : for AC 120V
AA-27 : for AC 230V
AA-26
or
AA-27
AC adaptor
To power outlet
NOTE:
Use specified attached AC adaptor only.
Main unbalanced power amplifier
Booth unbalanced power amplifier
Effects processor
R L R L R
L R L R R L R L R L R
KEY ADJUST PITCH
-12
SLOW BRAKE
Quartz 0
OFF ON
POWER
+12
START /STOP 78
33 45 DP-DJ151 Digital
Turntable 2
Mixer
Balanced microphone Effects processor
IN
Send
(Tip)
1/4" TRS jack
L
L R L
KEY ADJUST PITCH
-12
BRAKE SLOW
Quartz 0
OFF ON
POWER
+12
/STOP START 78
33 45 DP-DJ151 Digital
Turntable 1
CD player CD player
ENGLISH
OUT
Return
(Ring)
7