Table of Contents
Advertisement
8.5
Zooming of the Screen:
8.6
Other Functions:
² Î ¤ @ Â ½ Ä ¶
C:\pdp ¨ Æ ° È
\User Menu\UM_BenQ.doc 5/30/2002 8:42 PM
The Zooming keys include "Wide", "Zoom +" and "Zoom –".
By pressing the "Wide" key, you can zoom in the screen to its
largest size. You can then restore the screen to the original size by
pressing the "Wide" key again.
Note: 1. When PC signals are input, you can switch between the full
screen size and the original signal strength.
2. When video signals are input, you can switch among six
screen sizes, including Full, Fill Aspect Ratio, 4:3 to 16"9,
LB to 16:9, LB Subtitles to 16:9 and Anamorphic.
By pressing and holding the "Zoom +" key, you can zoom in the
screen gradually. By pressing and holding the "Zoom –" key, you
can zoom out the screen gradually to its original size.
Note: 1. You can only zoom out the screen gradually to its original
size by pressing the "Zoom –" key. The screen cannot be
zoomed out to a smaller size with this function.
2. When the image is zoomed in by using the "Zoom +" key,
you can use "▲", "▼", "◄" and "►" keys to adjust the
viewing area.
When the display cannot be showed after the change of the timing in
PC Input mode, press the "
automatically adjust the phase, horizontal/vertical position and color
temperature to optimize the display.
When the display cannot be showed after the change of the playback
system in Video Input mode, press the "
machine will select the appropriate format for the image system.
Note: For the information about the timing provided by the machine,
refer to Chapter 10.
Press the "Freeze" key to freeze (or suspend) the current screen.
You may press the "Freeze" key again to continue the playing.
Note: You can only freeze the screen by pressing the "Freeze" key. The
playback system keeps playing when the screen is frozen.
You can press the "PIP" key to show the picture-in-picture screen.
The screen will change as follows when you press the "PIP" key
consecutively:
Sub-picture open (small) → Screen (middle) → Screen (large) → Sub-picture closed
Note: The picture-in-picture screen can receive video images while the
PC outputs the display to the Main Screen, so the prerequisites for
the display of the sub-picture include:
1. A video module;
2. The Main Screen must be a PC display; and
3. The video image source must be connected appropriately.
The position to display the sub-picture and the video image source
must be set from the OSD menu.
" (AUTO) key. The machine will
26
" (AUTO) key. The
Wuys
Advertisement
Table of Contents
