Table of Contents
Advertisement
8. Basic Operation:
8.1
Power ON/OFF: The operation is in Standby mode:
8.2
Selection of Input Mode:
² Î ¤ @ Â ½ Ä ¶
C:\pdp ¨ Æ ° È
\User Menu\UM_BenQ.doc 5/30/2002 8:42 PM
Press the "POWER' key to turn on the Display.
indicator changes from red to green.
Press the "POWER" key in the Start state to turn off the Display.
The power indicator changes from green to red.
(Note: The power indication flashes for a few seconds before switching
the color.)
Press the "INPUT" key. The "OSD Menu" of input signal sources
appears. Use the "▲/▼" keys to select the signal source you want
and press "►" to confirm the selection.
Your may also press the "INPUT" key repeatedly to select the signal
source you want. The signal sources are displayed in the following
sequence (depending on the module, the sequence might be
different):
Where:
1. PC Module:
2. PC Module + Video Module:
3. PC Module + Enhanced PC Module:
RGB 1: Analog D-SUB input on PC module.
RGB 2: Digital DVI-D input on PC module.
RGB 3: Analog D-SUB input on enhanced PC module.
RGB 4: Digital DVI-D input on enhanced PC module.
23
The power
Wuys
Advertisement
Table of Contents
