Displaying A Basic Rotation; To Cancel A Basic Rotation; Displaying The Angle Of An Active Basic Rotation - HEIDENHAIN TNC 407 Manual

9 3D Touch Probes
9.2 Touch Probe Cycles in the MANUAL and ELECTRONIC HANDWHEEL Operating Modes

Displaying a basic rotation

The angle of the basic rotation appears after
ROTATION ANGLE whenever PROBING ROT is
selected. It is also shown in the additional status
display (see page 1-26) under ROTATION.
In the status display a symbol is shown for a basic
rotation whenever the TNC is moving the axes
according to a basic rotation.

To cancel a basic rotation:

0
9-10
Select the probe function with the soft key PROBING ROT.
Set the ROTATION ANGLE to 0.
ENT
Terminate the probe function.
END
Fig. 9.11:

Displaying the angle of an active basic rotation

TNC 425/TNC 415 B/TNC 407