Panning - Lexicon PCM 81 - REV 2 User Manual

PCM 81
Sw Value
T Lvl
T Src
The switch cycles between 127 and 0
as long as T Src is at or above T Lvl.
Switch
Mode
P Width
50
When Switch Mode is selected, transition
from 127 to 0 is instantaneous.
Ramp
Mode
P Width
50
When Ramp Mode is selected, transition
from 127 to 0 is continuous.
Sw 1
1 Cycl:2 Beat
P Width = 50
Sw 2
1 Cycl:3 Beat
P Width = 16
Sw 1&2
127
0
127
P Width 0
P Width
75
25
127
0
P Width
P Width
75
25

PANNING

Parameters in the Panning row provide control of panning of
individual effects voices, as well as a master panning parameter for
all voices.
Master
The Pan Master provides simultaneous control over the panning of
all voices in the effect. The range of the Pan Master is 50L (full left)
through L1, C (Center), 1R through 50R (full right) for a total of
101 positions. The Master Pan is additive to the individual voice
panners such that, if a voice is set to L10, and the Master is set to
20R, the voice will be at 10R.
Voices
Individual pan controls are provided to position the output of each
voice. The range of each voice is 50L (full left) through 1L, C
(Center), 1R through 50 R(full right) for a total of 101 positions.
PATCHING
The last row of each algorithm's edit matrix is the Patch row. This
row provides parameters for creating up to 10 patches in each
effect. Each row position (Patch 0-9) has three controls available:
Src, Dst, and Values. Press Load/✱ to cycle among these selections.
Src
Use ADJUST to select any of the sources listed below.
Dst
Use ADJUST to select any parameter except those on the Patch row.
Algorithms and Parameters
. . . continued on page 3-26
3-25