Eq Effects; Program Bank 2 (P2) - Lexicon PCM 81 - REV 2 User Manual

PCM 81
4.6 2WayStreet
Another variation of AmbientCarBy. This preset produces both
left-to-right and right-to-left drive-by effects — like listening to the
sound of traffic on a two-way street. The speed for each direction
is slightly different. ADJUST is a master speed control for both
eastbound and westbound traffic.
4.7 IntoTunnel
This preset simulates the sound of a source approaching you from
the side, passing you and then entering a tunnel. ADJUST controls
the speed of the source. To reverse the direction of the effect, set
the Width parameter to –45 — you'll find it in the Soft Row.
4.8 2WayTunnel
This is a variation of IntoTunnel. The source approaches and enters
the tunnel, then turns around and comes back. Use ADJUST to con-
trol the speed.
4.9 FinishLine
This preset adds two pairs of stereo delays to the basic drive-by
effect to simulate the 1st, 2nd, and 3rd place cars crossing the fin-
ish line. ADJUST controls the speed. Be sure to try this and the
other drive-by effects with different types of source material.
Almost any continuous source will produce interesting spatial
sound effects. Low, buzzy synthesizer tones work particularly well.
ADJUST: Speed 1–100
ADJUST: Speed 1–25
ADJUST: Speed 1–100
ADJUST: Speed 1–100

PROGRAM BANK 2 (P2)

EQ EFFECTS

0.0 StereoLoPass
This effect is a combination of a stereo low pass filter and a stereo
reverb, with the two effects in parallel. Use ADJUST to set the cut
off frequency of the filter. The reverb mix is turned all the way
down — you can add reverb by changing the FX Mix parameter in
the Soft Row, where you'll also find additional parameters for delay
voices, and image.
0.1 Low Pass HiQ
The same basic effect as StereoLoPass, but with feedback adjusted
to produce a more resonant filter. ADJUST sets the cutoff
frequency of the filter.
0.2 Low Pass LFO
The cutoff of the stereo low pass filter is swept with a rhythmic LFO
sine wave. Press Tap to synchronize the sweep with rhythmic
material. ADJUST controls the low frequency limit of the sweep.
0.3 StereoHiPass
A combination of a stereo high pass filter and a stereo reverb, with
the two effects in parallel. Use ADJUST to set the cutoff frequency
of the filter. The reverb mix is turned all the way down — you can
add reverb by changing the FX Mix parameter in the Soft Row,
where you'll also find additional parameters for delay voices, and
image.
Presets
ADJUST: CutOff 0–127
ADJUST: Cutoff 0–127
ADJUST: Depth 0–127
ADJUST: Cutoff 0–127
4-13