Lexicon PCM 81 - REV 2 User Manual page 59

PCM 81
Press Edit to jump directly to the FX Width parameter in the
Controls Row.
The FX Width value will be
changing from 0 to 90 and
back again.
The display will change to show position 0.5 in the Controls Row.
Note that the value is changing continuously from 0 to 90 and
back again. Notice also the small square in the upper right corner
of the display. This patch destination indicator appears whenever a
parameter has been assigned as a patch Destination in the effect
being edited.
Now let's return to the Patch row to add a pivot point to the effect.
Press Edit to jump back to the Patch row.
Press Load/✱ to bring up the Values display. The last value edited
will be displayed, so you will see either the minimum or maximum
value.
Patch Destination Indicator
I
✱
✱
If the ✱ is not at the left of the Source value, press Load/✱ three
times to move it there. (You can take a short cut instead —
simultaneously press Down and Load/✱ to back-step.)
✱
Turn ADJUST to display 64. This will be the Source value of our new
pivot point. The string of dots in the destination value portion of
the display indicate that there is no Destination value assigned
when the source value is 64.
✱
Press Load/✱ to move the ✱ to the right of the Source value, and
turn ADJUST clockwise to set the Destination value for this point to
–45.
✱
Basic Operation
or
✱
or
✱
2-37