Table of Contents
Advertisement
To reset the Nokia 5i and Nokia 10i to factory defaults
1. Remove power.
2. Press the Reset switch.
3. Apply power and keep the switch pressed until the "wait after 0" message
For the front panel descriptions, see
Performing the Initial Hardware Configuration
The first time you turn on power to a Nokia 5i or Nokia 10i gateway, the
initial hardware configuration process begins.
This section describes how to perform the initial configuration manually by
using a console connection. It includes the following sections:
Note
Nokia recommends that you install all hardware components before you
perform the initial hardware configuration.
Nokia 5i and 10i Installation Guide
Use a large flat-tipped object, such as a thick paper clip, to press the reset
switch. Do not use a sharp pin or thin piece of metal to press the reset
button.
appears on the console port.
The kernel boots and starts the configuration wizard.
Connecting the Console Port
Connecting Power and Turning the Power On
Performing the Initial Hardware Configuration
"System Status LEDs"
on page 31.
25
Advertisement
Table of Contents
