Creating An Index For An Rmon History - Cisco 11503 - CSS Content Services Switch Administration Manual

Chapter 6 Configuring Remote Monitoring (RMON)
Table 6-3
The following running-configuration example shows the results of entering the
commands in
!************************ RMON HISTORY ************************
rmon-history 5

Creating an Index for an RMON History

The RMON history index identifies the history to the CSS. The RMON history
index allows you to assign specific configuration attributes to the RMON history
index. When you create an RMON history index, you access the configuration
mode for that history automatically.
To create a history index, use the rmon-history index command from any
configuration mode except boot configuration mode. The index is an integer from
1 to 65534.
The RMON history index 65535 is administratively predefined and cannot be
Note
modified. If you enter this index number, a message similar to the following
appears:
To create an RMON history identifier 5, access global configuration mode and
enter:
(config)# rmon-history 5
OL-5647-02
RMON History Configuration Quick Start (continued)
Steps and Possible Settings
Define the bucket count for the interval. Enter an integer from 1 to 65535.
5.
The default is 50.
(config-rmonhistory[5])# requested-buckets 25
Activate the history.
6.
(config-rmonhistory[5])# active
Table 6-3.
owner "Boston_Tech_Lab"
data-source ifIndex.3
interval 60
requested-buckets 25
active
%% Index internally used. Administrative control not allowed.
Cisco Content Services Switch Administration Guide
Configuring an RMON History
6-23