Configuring Logging For A Subsystem; Enabling And Disabling Logging For A Subsystem - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Chapter 4
Using the CSS Logging Features
Configuring Logging for a Subsystem
Enabling and Disabling Logging for a Subsystem
OL-5647-02
To send the logging output directly to the log file, enter:
(config)# no logging buffer
This section describes how to select a CSS subsystem and log activity for the
subsystem. This section includes the following topics:
Enabling and Disabling Logging for a Subsystem
•
Configuring a Log Message for a Subsystem at a Logging Level
•
Logging ACL Activity
•
Sending Log Messages to an E-Mail Address
•
By default, the logging levels for all CSS subsystems is set at warning-4. The level
you specify instructs the CSS to log subsystem activity that occurs at that level
and the activity greater than that level. For example, if you wish to log
informational messages (info-6), the CSS also logs notice, warning, error, critical,
alert, and fatal error levels.
Use the logging subsystem command to select a CSS subsystem and determine
which type of activity to log.
To reset logging for a subsystem to the default logging level (warning-4), enter
the no version of the logging command. For example:
(config)# no logging subsystem redundancy
The following example enables logging for the chassis subsystem with a critical-2
error level. The CSS logs all critical, alert, and fatal errors for the chassis.
(config)# logging subsystem chassis level critical-2
Cisco Content Services Switch Administration Guide
Configuring Logging for a Subsystem
4-7
Advertisement
Table of Contents
