Copying Configuration Information From The Active Scm To The Passive Scm - Cisco 11503 - CSS Content Services Switch Administration Manual

Configuring a Boot Configuration Record for the Passive SCM
Copying Configuration Information from the Active SCM to the
Passive SCM
Cisco Content Services Switch Administration Guide
2-16
To copy the primary and secondary boot configuration record from NVRAM of
the active SCM to the passive SCM, use the passive sync command. For the CSS
11506, the passive sync command also copies the startup- configuration file and
synchronizes the clock time from the active SCM to the passive SCM. This
command is available in boot mode.
To synchronize specific boot configuration, startup configuration, or clock time
information between the active SCM and the passive SCM in a CSS 11506, use
the following commands:
passive sync boot-config - Copies the boot configuration record from the
•
active SCM to the passive SCM.
passive sync startup-config - Copies the startup-config file from the active
•
SCM to the passive SCM.
passive sync image - Copies the ADI of the boot-image file from the active
•
SCM to the passive SCM.
passive sync time - Synchronizes the clock time of the passive SCM with the
•
active SCM.
To copy the primary and secondary boot configuration record, startup
configuration, and clock time on a CSS 11506, enter:
(config-boot)# passive sync
To copy the boot configuration record from the active SCM to the passive SCM in
a CSS 11506, enter:
(config-boot)# passive sync boot-config
Chapter 2 Specifying the CSS Boot Configuration
OL-5647-02