Viewing Or Changing The Ethernet Port Settings - D-Link DSN-500 Software User's Manual

3. In the Ping to field, type the IP address of the destination device you want to ping.
4. Click OK.
The results of the ping appear in the Ping Results field.
5. If the ping is successful, click the Close button. If the ping fails, verify that the
Management Center's IP address is not active elsewhere on the network.

7.3 Viewing or Changing the Ethernet Port Settings

You can view the settings of the storage system's Ethernet (iSCSI) ports and change the
port's maximum transmission unit (MTU) setting, and enable or disable the network port. If
you change the MTU setting, you must restart the storage system for the new setting to take
effect.
To view Ethernet port settings and/or change the MTU setting:
1. In the Network Settings View, click an Ethernet port in the Main Display.
The Port tab shows the settings for the selected Ethernet port (see Figure 7-4).
xStack Storage Management Center Software User's Guide
Figure 7-3. Ping from Management Port Dialog Box
105