Fastening A Non-Lacie Hard Disk To A 5Big Enclosure Drive Tray - LaCie 5big Backup Server Configuration Manual

LaCie 5big Backup Server
Configuration Guide
6.1.1. Fastening a non-LaCie Hard Disk to
a 5big Enclosure Drive Tray
IMPORTANT INFO: Drives sold by LaCie are the preferred choice
when using your 5big Backup Server. LaCie disks specially prepared
for the 5big enclosure are tested and shipped in a drive tray for
easy installation. Additionally, all 5big hard drives include a 3-year
warranty. Visit www.lacie.com
a 5big disk drive.
Please note the following before fastening your non-LaCie hard
drive to the drive tray:
✦ Only 3.5" SATA II drives may be used in the 5big enclosure.
Please visit the Support page at
drives that have been tested by LaCie. LaCie cannot guaran-
tee performance or compatibility with the 5big Backup Server
when using drives that have not been tested by LaCie.
✦ Windows Home Server cannot add more than 2TB of a single
disk to its pool of Storage Hard Drives. For example, if you
add a 3TB non-LaCie drive into the pool of Storage Hard
Drives, Windows Home Server will only use 2TB of its capacity.
The remaining storage will be placed in the System as unavail-
able.
✦ Use only the screws supplied in your packaging when fasten-
ing the non-LaCie hard drive to the drive tray
✦ To avoid potential problems caused by electrostatic discharge
(ESD), it is recommended that you do not touch the hard
drive's printed circuit board
touching the hard drive printed circuit
caution against ESD, please use an anti-static wristband or
an anti-static mat to ground yourself when handling the hard
drive.
for more information on purchasing
www.lacie.com for a list of
(Fig. 68)
(Fig. 69 - To prevent ESD, avoid
board). As a further pre-
continued on the next page>>
Fig. 68
Fig. 69 - To prevent ESD, avoid touching the hard drive
printed circuit board
Disk Installation
page 40