Information On The Sensor Label - Simrad PI DEPTH - MANUAL 2 Instruction Manual

Information on the sensor label

316870/A
The sensor label provides the following information.
Figure 3 The PI Remote/Depth sensor label
D
A
B
C
(A) Channel identification. You must write down the channel
currently used by the sensor to communicate with the PI system.
The green background colour on the label is chosen to remind
you that the sensor is mounted on the starboard trawl door.
(B) This information identifies the sensor type. Three types are
available:
• PI-RD300: PI Remote/Depth for maximum depth 300 m
• PI-RD600: PI Remote/Depth for maximum depth 600 m
• PI-RD1000: PI Remote/Depth for maximum depth 1000 m
(C) Order number.
(D) Opening for the water to access the pressure sensor.
(E) Water switch. This is a sacrificial bolt. Check it from time to
time to make sure that it has not worn out.
(F) The sensor's serial number.
F
E
(CD012201D)
Introduction
7