Care Instructions; Important Information - CONCORD ULTIMAX Manual

Hide thumbs Also See for ULTIMAX:
Table of Contents

Advertisement

7. Care instructions

Removing the seat covers to
wash:
The cover is composed of two
parts which are secured to the
seat by means of Velcro tape,
buttonholes and tapes. Once
these ties have been released
the two parts of the cover may
easily be removed. To fit the
covers, proceed in the reverse
order (seat shell and head
section).
When they come into contact
with moisture, especially during
washing, the cover fabrics can
easily fade. Do not use solvents!
30°

8. Important information

Please note the instructions in
the car's operating manual for
transporting children in a car.
Information on the use of child
seats together with an airbag
should be observed with
particular care.
Children sometimes have items
in their jacket or trouser pockets
(e.g. toy) or wear hard items that
are attached to their clothes (e.g.
belt buckle). Check that these
items do not come between the
child and the safety belt – they
could cause unnecessary injuries
in the event of an accident. These
hazards also apply to adults!
Naturally children can often be
very lively. You should therefore
explain to children how important
it is to always be safely fastened
in. Children must understand that
they should never change the
way the belts are positioned, and
never open the buckle.
Only if safety equipment is
correctly installed and used can
your child enjoy maximum safety.
All straps in the child restraint
system and all belts required for
securing the seat in the car must
be fitted tautly and without twists,
and must be protected against
damage.
Protect those parts of the restraint
system that are not covered in
fabric from direct sunlight to avoid
your child being burned.
The child restraint system must
not be damaged or trapped by
moving parts in the car interior
or by doors.
Never modify the restraint system
in any way – this will endanger
your child's safety.
After an accident the whole child
restraint system must be
replaced or returned to the
manufacturer for testing along
with a report of the accident.
0259-00

Advertisement

Table of Contents
loading

Table of Contents