General Instructions - CONCORD INTENSE - ANNEXE 934 Manual

_ GENERAL INSTRUCTIONS

You must follow these instructions to ensure that your baby
is adequately protected, comfortable and securely fastened
inside the car:
• Your CONCORD INTENSE safety seat can be installed on
both the front seat, if it is not fitted with an Air-Bag, and
the back seat of the car. In any event, we recommend
that you fit on the back seats. If you position it on the
front seat of the car, this must NOT have an AIR-BAG or it
must be disconnected.
• It is only valid for cars fitted with automatic three-
point fastening seat belts, approved in accordance with
Regulation ECE-16, or other equivalent regulations. Do
NOT use it with a two-point fastening belt.
• Not all safety systems are exactly the same, so we
recommend that you check your CONCORD INTENSE in
the car where you are going to install it.
22
manual-INTENSE-090313_D-IT.indd 22
• It is very important that you do not use second-hand
products, as CONCORD can only guarantee complete
safety on items used by their initial buyer.
• CONCORD recommends that you replace your
CONCORD INTENSE safety seat with a new one when it
has undergone violent pressure following an accident.
• Check that all the seat belts are in the correct position
and correctly adjusted to your CONCORD INTENSE.
Ensure that none of the seat belts is coiled up.
• To help your baby grow correctly, we advise that you do
not over-use the safety seat on long journeys, and that
you frequently lay them stretched out in a Moses basket
or bed.
13.03.09 09:43