Using The Sun Visor; Use On A Buggy Frame; Care Tips - CONCORD air.safe Manual

_ USinG THE SUn ViSoR

Image 15 - The sun visor (11) of the CONCORD AIR is stored in the
bag (13) at the rear of the child seat. Use the snap fasteners to attach
the sun visor to the head rest (03). Extend the sun visor and insert the
holders in the relevant openings on the carry handle (01).
Check the attachment points for proper mounting and hold.

_ USE on a bUGGy FRamE

(See front of the outer sleeve of the user manual)
The CONCORD AIR can be mounted on any CONCORD buggy frames
equipped with ProFix connectors. Make sure that the seat anchoring
audibly clicks into place, and that both safety displays on the ProFix
controllers (14) on the joint of the carry handle (01) show GREEN.
To release the CONCORD AIR from the buggy frame, pull the ProFix
control (14) on the carry handle (01) up, and lift the child seat upwards
and off the buggy frame.
24

_ CaRE TiPS

Removing the cover - To remove the cover for washing, begin with
the cover over the headrest. Place the headrest (03) in the highest
possible position, and open the harness lock (07) (Image 2 - Image 4).
Remove the harness padding from the shoulder straps, remove the
seat minimiser (06) (see ‚THE SEAT MINIMISER'), and pull the cover
off the attachment points on the upper edge of the headrest (03).
Thread out the shoulder straps, and pull the cover towards you off the
headrest, and downwards from the backplate. Unfasten all attachment
pieces on the cover of the seat area, and thread the harness lock (07)
out through the opening in the cover. Pull the cover of the seat area up
and off via the headrest (03) and pull it towards you off the seat.
Attaching the seat cover after cleaning - simply reverse the
sequence described above. Pull the cover of the seat area down via
the headrest (03). Thread the harness lock (07) through the opening
in the cover. Insert the cover at the harness openings and behind the
headrest (03) into the attachment grooves, pull the cover over the front
edge of the CONCORD AIR and close all snap buttons.
Thread the shoulder straps through the relevant openings in the cover
of the headrest, and pull the cover upwards over the back plate, and
then over the headrest (03) from the front. Attach the cover at the
attachment points at the top edge of the headrest (03). Install the
harness pading (04) in such a way that the closed sides face towards
the child.
Check that all parts of the cover are placed correctly, that the
harnesses are not twisted, and that all attachment bits are closed
properly.
25