T-Rex 20450 Manual

20450
94-01 DODGE
R AM T R UCK
BILLET INSERT
94-01 Dodge Ram & 94-98 Ram Sport Models
Tools Required:
Phillips Screw Driver
Needle Nose Pliers
Drill & 1/8" Drill Bit
Read and understand instructions before attempting installation
Step1
Remove the hood safety release handle by unfastening plastic retainer. Remove the six 8mm nuts holding
grille shell to hood and loosen five 8mm bolts holding grille shell to black steel frame support. Remove the
six 8mm bolts holding the black steel frame to the hood. Now remove the factory grille from vehicle.
Step3
Center the billet inserts behind the grille shell. Drill 1/8" hole in the outside verticals of the black steel frame
through the holes provided in the outside tabs on the billet inserts. Attach with the #10 screws and flat
nuts. Make sure the inserts are centered; Align the three hole attachment bracket with the center vertical of
the black steel frame and inserts (the center hole in the bracket is offset to align with the center steel bar,
so it will only fit one way). Drill three 1/8" holes and attach the outer holes to the insert with smaller #8
screws and flat nuts; Use the remaining #10 screws and flat nuts to attach the bracket to the steel frame
provided.
Billet Insert (4 PC Style/Look)
Hardware / Parts List:
2 Billet Insert (12 bars)
2 #8 x ¾" Phillip Screw
2 #8 Flat Nuts
Step2
Separate the steel frame from the grille shell. Remove
the honeycomb inserts from the grille shell by gently
twisting the tabs with a needle nose pair of pliers. Re-
install the steel frame and loosely attach the five 8mm
bolts.
Step4
Install the grille assembly on the vehicle. Before tightening
hardware, push the inserts and steel frame toward the plastic
shell (make sure the inserts are centered). Re-install the hood
safety latch.
grille.
6/29/05
20450
94-01 DODGE
R AM
3 #10 x 1" Phillip Screws
3 #10 Flat Nuts
1 Attachment Bracket (3 hole)
Thank you for purchasing a T-Rex billet
T R UCK
BILLET INSERT