Related Manuals for Black Horse Off Road 17DG109MA
Summary of Contents for Black Horse Off Road 17DG109MA
- Page 1 BLACK MODULAR GRILL GUARD FOR DODGE RAM 1500 2009-2018(Excl. Rebel Trim) INSTALLATION INSTRUCTIONS BLACK MODULAR GRILL GUARD FOR DODGE RAM 1500 2009-2018 (Excl. Rebel Trim) / 2019-2020 RAM 1500 Classic PART # 17DG109MA Page 1 of 8...
-
Page 2: Parts List
PARTS LIST: Qty Description Description Grille Guard Lock nut M12 Upper Frame Bracket (for trucks without tow hooks only) Hex bolt M12_40 Driver/Left Lower Mounting Bracket Flat washer D8(8x24x2mm) Passenger/Right Lower Mounting Bracket Lock nut M8 Passenger/Right Top Bracket Button Head Bolt M8_25 Driver/Left Top Bracket Flat washer D12(12x37x3mm) Passenger/Right Support Bracket... - Page 3 d. Install the driver side Lower Support Bracket with the bent end toward the front of the vehicle, (Figure 3). Bolt the Support Bracket to the inside of the Lower Mount using the top round hole in the Lower Mounting Bracket with the included (1) 12mm x 35mm Hex Bolt, (2) 12mm Flat Washers, (1) 12mm Lock Washer and (1) 12mm Hex Nut, (Figure 4).
- Page 4 To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Grille Guard.
- Page 5 Driver Side Installation Pictured (2) 12mm Flat Washers (2) 12mm Lock Washers Factory hex nuts (2) 12mm Hex Nuts Remove the (2) factory hex nuts from tow hook Front Front Fig 4 IMPORTANT: For models without tow hooks, only use the supplied 12-1.5mm x 30mm Fine Thread Hex Bolt 12mm Lock Washer 12mm Flat Washer...
- Page 6 Driver Side Installation Pictured Reuse factory hex bolt 12mm x 35mm Hex Bolt (2) 12mm Flat Washers 12mm Lock Washer 12mm Hex Nut Remove factory hex bolt Front Fig 8 Front Factory hex bolt Fig 9 Installation pictured without the splash guard for instruction purposes only (3) 12mm x 35mm Hex Bolts Front...
- Page 7 Driver Side Installation Pictured Hold the splash guard up to the brackets and mark location for cutting to clear brackets. Cut only what is needed to insert bracket through the splash guard of the splash guard. Do not cut through the front or rear edge of the Front splash guard...
- Page 8 Figure 1 Lock nut M8 Flat washer D8 Spring washer D8 Button Head Bolt M8_25 Figure 2 Right Brush Guard Left Brush Guard Page 8 of 8...
Need help?
Do you have a question about the 17DG109MA and is the answer not in the manual?
Questions and answers