Related Manuals for Black Horse Off Road 17FP30MSS-PLR
Summary of Contents for Black Horse Off Road 17FP30MSS-PLR
- Page 1 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 INSTALLATION INSTRUCTIONS S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 PART # 17FP30MSS Page 1 of 8...
-
Page 2: Parts List
S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 PARTS LIST: 1 Grille Guard 4 10mm Plastic Washers 1 Driver/Left Frame Mounting Bracket 4 10mm x 27mm x 3mm Flat Washers 1 Passenger/Right Frame Mounting Bracket 2 10-1.5mm Nylon Lock Nuts 1 Driver/Left Top Bracket 4 12mm Plastic Washers 1 Passenger/Right Top Bracket... - Page 3 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 PROCEDURE: REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. CUTTING IS REQUIRED ON VEHICLES WITHOUT TOW HOOKS. LICENSE PLATE MUST BE RELOCATED ON VEHICLES EQUIPPED WITH ECOBOOST.
- Page 4 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 Bolt, (1) 12mm Lock Washer and (1) 12mm Flat Washer, (Figure 9B). IMPORTANT: Do not tighten hardware at this time. NOTE: It may be necessary to raise or lower the height of the Top Bracket to fit properly between the grille and the top of the bumper.
- Page 5 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 Driver Side Installation Pictured Front guard installation Nut M8 Flat washer D8 Right Brush Guard Left Brush Guard Spring washer D8 Hex bolt M8_25 M8_25 Fig 0A Fig 0B Remove tow hooks if equipped Fig 2A Front...
- Page 6 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 Driver Side Installation Pictured Front Insert 12mm Bolt Plate through Fig 5A outermost hole in bumper bracket (Fig 5B) Insert Nut Plate through opening in end of frame (NOTE: Tow hook model pictured for instruction purposes only) Front Driver side frame...
- Page 7 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 Driver Side Installation Pictured Use factory hex bolt Fig 9A Front Cover a section (dotted line) of the bottom of the Bracket with Foam Tape to prevent damage to finish on bumper Front Fig 9B 12mm x 35mm Hex Bolt...
- Page 8 S/S MODULAR GRILLE GUARD FOR FORD F150 09-14 Driver Side Installation Pictured Front Put one Hex bolt M10_35 & one Flat washer D10(10x30x2.5mm) between the guard and bracket. Hex bolt M10_35 Flat washer D10(10x30x2.5mm) Fig 13 Fig 14A Front Do not cut through top or bottom edge of bumper cover Fig 14B...
Need help?
Do you have a question about the 17FP30MSS-PLR and is the answer not in the manual?
Questions and answers