SPX OTC Easy Lever 5095A Parts List & Assembly Instructions

Easy Lever™ Tire and Wheel Caddie
The Easy Lever tire and wheel caddie makes moving tires and wheels an easy task. Use the following steps
to assemble the Easy Lever:
1. Secure the handle over the U-frame, as shown,
using two hex head bolts, two spring washers, two
flat washers, and two nuts.
2. Fasten the kickstand under the frame tabs using a
hex head bolt, a spring washer, and a flat washer.
NOTE: Fully tighten all nuts at
this time. To prevent damage
to the kickstand, do not
overtighten its bolt.
The number of parts included in the
Easy Lift tire and wheel caddie kit is
identified in parenthesis on the
illustration. Parts not identified with a
number are single units.
Replacement Parts:
Items
Kit No. Included Description
in Kit
533873 Wheel/Axle Kit
*
533874 ‡ Roller Kit
533875 # Kick Stand/Hardware Kit
© 2005 SPX Corporation
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
U-frame Assembly
Lock Nut (2)
‡
Hex Head Bolt (2)
‡
Pin (2)
*
Wheel (4)
*
Roller Bracket (2)
‡
Roller (2)
‡
Wear eye protection that
meets ANSI Z87.1 and OSHA
standards.
Parts List &
Assembly Instructions
for:
Handle Sleeve
Handle
Hex Head Bolt (3)
#
Spring Washer (3)
#
Flat Washer (3)
#
Shaft (2)
*
Form No. 532533
Sheet No. 1 0f 1
Issue Date: September 26, 2005, Rev. A
5095A
5096A
Kickstand
#
Nut (2)
#