Vivo STAND-V101GT Manual

BEFORE ATTEMPTING TO ADJUST PNEUMATIC ARM
Adjusting Pneumatic Tension
1 Mount Your Monitor
Follow assembly manual instructions.
2 Insert Allen Wrench
Into Adjustment Screw
Adjustment screw is located on the back of
the monitor arm. Refer to assembly manual
for correct Allen wrench selection.
Clockwise:
Decrease Support
[if monitor will not lower]
Turn the adjustment screw clockwise to
decrease the support for your monitor,
allowing it to be lowered.
02/01/24 - REV 1
REVIEW THIS GUIDE
to Support Your Monitor
Getting Started
Tension Adjustment Guide
3 Turn 10-20x to
Counterbalance Weight
Use the guide below to adjust the
tension according to the amount of
counterbalance needed for the arm to
support the monitor.
Counter-Clockwise
Increase Support
[if monitor will not raise]
Turn the adjustment screw counter-clockwise
to increase the support for your monitor,
allowing it to be raised up.
STAND-V101GT