Other Footswitch Functions - DigiTech Artist 2120 User Manual

Valve guitar system programmable dual tube preamp/processor and foot controller

Manual (1 page)

Table of Contents

Section - 5 The 2120 FC

To assign any currently selected Parameter to a footswitch or Expression pedal in the

currently selected bank, do the following:

1. Be sure that the Parameter you want to link is displayed and selected (below is an example the gain setting of the Tube Distortion

module.). The display should appear something like this:

2. Turn the <4> knob to select the gain parameter, then press the <Assign> button once. The display reads:

3. Select the footswitch or move the expression pedal to be used. An example would be to use Exp 1. From there, use knobs <3>

and <4> to set the minimum and maximum ranges of the gain. Once this is done, the display will appear something like this:

4. To exit the parameter assignment mode press the <Program> button to return to Program mode. The <Store> button will stay

bright until these changes are stored, or the program is changed.