2120 Vgs Artist Into A Pair Of Combo Amps - DigiTech Artist 2120 User Manual

2120 VGS Artist
Using a set-up similar to the one shown above will give you the chance to optimize the potential of both the 2120 VGS and the combo
amplifiers.
The best signal route for a combination such as this one, is to first run out of the guitar output into the input jack of the 2120 VGS. Then, if
you prefer to use an additional effect unit in the signal path, you can utilize the programmable mono FX loop of the 2120 VGS. In doing this,
you will want to run from the fx send of the 2120 VGS into the selected effect unit. From the chosen effect unit, run out of either its output
back into the FX return of the 2120 VGS. From the 2120 VGS, you will now want run out of both the left and right outputs of the 2120 VGS
into the input jacks of both combo amps.
You will be able to achieve lush, smooth stereo effects, while retaining the great amp tones of both the 2120 VGS and the Combo Amps.
As usual, make sure that all of the connections are good and solid when making the connections. It is also a good idea to make sure that the
signal levels going from one unit to the other are even. Meaning that the output level going into the input of the receiving unit is not set so
high that it distorts (or clips) the input section. Always remember that the better your rig sounds clean, the better your 2120 VGS will sound.
User Guide
2
Sastch 2
0
1
LINK CHANGED
COMP
FACTORY USER
SEAMLESS
Input
Page 1
Clip
Right Out
Left Out
2120 VGS into a Pair of Combo Amps
Input
FX Send FX Return
Program
Effect
0 0 100 %
2 3 4
dB dB dB
LINK CHANGED LINK CHANGED LINK CHANGED
WAH TUBE EQ GATE L/R OUTS
DIGITAL
CLIP
2 3 4
Section - 2 Setting Up
(Optional)
13