Section 3 - Editing Programs; Selecting A Program; Selecting Effect Configurations - DigiTech Artist 2120 User Manual

2120 VGS Artist
Section - 3 Editing Programs

Selecting A Program

When you first turn on your 2120 VGS, it boots up in Program mode and the display will appear something like this:
To select a Program, do the following:
1. Make sure Program mode is selected (the <Program> button will be brightly lit). If the <Program> button is dim, press it
once to return to Program mode.
2. Use the <Program> button to select the Program bank (Factory or User). Each successive press of the <Program> button
toggles between the Factory and User bank of programs.
3. Using the <Program/Effect> wheel, scroll to the program you want to hear.

Selecting Effect Configurations

The 2120 VGS gives you the ability to select any one of the twenty-four different effect routing configurations within the selected program. The
procedure to do so is as follows:
1. From Program mode, press the <Other> button. The display appears something like this:
2. Notice that the entire digital effects screen is flashing. At this point turn the <1> knob under the display to select any one of the
twenty-four different effect routing configurations available in the 2120 VGS. Once you have the desired Effect configuration
selected, you can load the effect modules you need for your particular program needs. press the <Store> button to save any
changes. Pressing the <Program> button will return you to Program mode.
User Guide
2
Satch 2
0 %kHz 0 %kHz
1 2
msdB msdB
LINK CHANGED LINK CHANGED
COMP WAH TUBE EQ
U SER
SEAMLESS
1 1
PAGE OF
2
Config:1 SDISC
2
1 2
LINK CHANGED LINK CHANGED
COMP WAH TUBE EQ
U SER
SEAMLESS
1 2
PAGE OF
Section - 3 Editing Programs
0 %kHz 100 %
3 4
msdB
LINK CHANGED LINK CHANGED
GATE
L/R OUTS
CLIP
2,2
3
LINK CHANGED LINK CHANGED
GATE
L/R OUTS
CLIP
19