Basic Specs; In 2 Out; Programmable Fx Loop; Signal Flow - DigiTech Artist 2120 User Manual

Section - 1 Introduction
Basic Specifications
1 Input and 2 Outputs Balanced (TRS)
With the 2120 VGS, the input and output are set up in a mono input and stereo or mono output configurations. The input jack of the 2120
VGS is located on the front panel of the unit. The output jacks are TRS (tip-ring-sleeve), and are a Left (mono) and Right output configuration
for full stereo separation of effects.
Programmable Mono FX Loop
For those of you that feel the need to add additional effects to the already extensive menu of sounds , the 2120 VGS provides a programmable
line level mono programmable FX loop. The signal leaves the unit after the Wah section of the 2120 VGS and returns just before the Dual
distortion paths. For a better representation of the FX loop, please refer to the signal flow chart below.

Signal Flow

Listed below, is a chart showing the signal flow path of the 2120 VGS. Notice that with the 2120 VGS, you have the choice of selecting either
one or both of the Distortion signal paths. Also take notice that a noise reduction system is available in the Analog Preamp section and the first
DSP section, making for ultra-quiet performance.
Analog Section
Input Buf.
10
Gate Det.
Clip LED
Comp
10 GEQ
Speaker
St. Gate
Cabinet
10 GEQ
Emulator
DSP Section-1
FX Loop
SS Dist.
Wah
Tube Dist.
Global/
Local
S-DISC II
3-Band
EQ
DSP Section-2 Dual S-DISC IIs
2120 VGS Artist
Bar
Graph
A/D
SoloBoost
S-DISC II
User Guide