Naming The Default; Storing The Default - DigiTech Artist 2120 User Manual

2120 VGS Artist

Naming the Default

1. Using the <Program/Effect> wheel, change the character to the one you want in the selected position.
2. When the correct character is displayed in that position, use the <Page> knob to scroll the cursor to the next character you
want to change.
3. Use the <1> to change the letter's case. Use the <2> knob to select numbers. The <3> knob is used to insert spaces. The
<4> knob is used to copy and paste characters.
4. To copy a character, position the cursor under the character you want to copy (using the <Page> knob), then turn the <4>
knob clockwise. To paste the copied character, position the cursor where you want to paste the character, then turn the <4>
knob counter-clockwise.
5. To abort the procedure, push either the <Program> button to take you to Program mode, the <Edit> button to take you to FX
Edit mode, or the <Utilities> button to take you to Utility mode, depending upon which mode you want to enter.

Storing the Default

1. When you have the name as you want it to read, press the <Store> button. The top line of the display reads:
This screen allows you to select the location of the new User default. Note that when the Default is stored, it is stored in the User bank of
Defaults because Factory defaults cannot be overwritten.
2. Use the <2> knob to select the Default number where you want to store the new default.
3. Press <Store> again. The Default is saved off and you now prompted to store these changes to the program. If you wish to store
these changes to the program, press the <Store> button again, otherwise, press the <FX Edit> button.
4. To abort the procedure, push either the <Program> button to take you to Program mode, the <Edit> button to take you to FX
Edit mode, or the <Utilities> button to take you to Utility mode, depending upon which mode you want to enter.
User Guide
Store To: [Name]
Section - 3 Editing Programs
25