PowerTec 71579 Instruction Sheet

INSTRUCTION SHEET
Router Table Set-up Bars
SAFETY RULES
WARNING
To reduce the risk of injury, turn machine off
and disconnect it from power source before
installing and removing accessories. An
accidental start-up can cause injury.
To Set Precise Depth of Cut
Select the desired set-up bar
and place the concave section
of the bar over the router bit or
saw blade. Adjust the router
bit or saw blade to touch the
set up bar as shown.
For your own safety, read and follow all
safety procedures listed in the machine
instruction manual.
HOW TO USE
To Check the Depth of Cut
After each pass, use the step
up, on the other side of the
same bar, to test the depth of
cut as shown.
Visit us on the web at
www.powertecproducts.com
Put these instructions and the
original sales invoice in a safe,
dry place for future reference.
Southern Technologies, LLC
Chicago, IL 60606
Model No. 71579
WARNING
To Set Fence Distance from
Blade/Bit
Use the step on the end of the
bar to set the distance from
the fence to the router bit or
saw blade as shown.
22-0809