Loading Using Tftp - 3Com LS8M1P12TEH Installation Manual

Installation Manual
H3C S7500 Series Ethernet Switches
User(none):lyt
331 Give me your password, please
Password:
230 Logged in successfully
[ftp] get SWITCH002.app SWITCH002.app
[ftp] get Switchbtm.app Switchbtm.btm
[ftp] bye
Note:
You can download two versions of host software and specify one as the primary and
the other as the backup.
2) Load the Boot ROM.
<H3C> boot bootrom Switchbtm.btm slot
Board 0 upgrading BOOTROM, please wait...
Upgrade board 0 BOOTROM succeeded!
3) Load the host software.
Load the primary file.
<H3C> boot boot-loader primary SWITCH002.app
Load the backup file.
<H3C> boot boot-loader backup SWITCH001.app
<H3C> display boot-loader
The primary app to boot of board 0 at the next time is: flash:/SWITCH002.app
The backup app to boot of board 0 is: flash:/SWITCH001.app
The app to boot of board 0 at this time is: flash:/SWITCH001.app
<H3C> reboot
system, in case the configuration is lost after the reboot.
Now you have completed the downloading of Boot ROM and host software.
Note that you must reboot the switch to validate host software downloading. If the Flash
memory is not large enough, you can delete some program files (for example, the host
program that is no longer in use) from the Flash memory after loading the Boot ROM.
Then you can upload the host program to the switch through FTP. Do not power off the
switch during the loading process.

7.3.2 Loading using TFTP

Loading using TFTP is similar with loading using FTP, except that the protocol used for
downloading is TFTP. In this case, the switch can only be used as a TFTP client to
download the software to its Flash memory from the TFTP server. After the
//Check whether other configuration is saved before rebooting the
7-13
Chapter 7 Software Maintenance
0