In Other Grounding Environments - 3Com LSBM1SRP1M1 Installation Manual

Installation Manual
H3C S9500 Series Routing Switches
1) Remove the screw from the grounding hole in the switch chassis.
2) Wear the connector of the PGND wire accompanied with the switch on the
grounding screw.
3) Insert the grounding screw into the grounding hole and screw it down.
4) Connect the other end of the PGND wire to the ground bar of the switch, as shown
in Figure 3-4.
Figure 3-4 Connect the PGND wire
Note:
Generally, the cabinets installed in equipment rooms are equipped with ground bar. In
this case, you can connect the PGND wire of the switch to the ground bar for it.

3.5.2 In other Grounding Environments

The following are some methods for grounding the switch in different grounding
environments.
3-5
Chapter 3 Switch Installation