3Com LSBM1SRP1M1 Installation Manual page 96

Installation Manual
H3C S9500 Series Routing Switches
4. Modify serial interface boot parameter
0. Return to main menu
Enter your choice(0-4):3
Note:
After changing the baud rate, you must close the terminal emulation program and
start it again for at least once in order to validate the new baud rate.
In a Windows 98 operating system environment, you can perform the operations of
disconnection and reconnection after changing the baud rate. In a Windows 2000
operating system, however, you must disconnect the terminal before setting the
baud rate and connect the terminal after finishing the work.
5) Select a right place to store the downloaded file as needed. For example, enter 3
at the prompt displayed in the last step to download the file into the CF card of the
switch, press Enter, and the system will display the following information on the
terminal:
Please Select File .
XMODEM downloading ...CCC
6) Select Transfer > Send File in the terminal window. Click Browse in the pop-up
dialog box (shown as the following figure), select the desired application, and
change the protocol used for downloading to XModem.
Figure 5-13 Send File dialog box
7) Click Send and the following interface pops up.
Chapter 5 Switch Monitoring and Maintenance
5-18