H3C LS-3100-16TP-EI-H3-A-O Installation Manual page 64

Installation Manual
H3C S3100 Series Ethernet Switches
both sides of the AC power input, and then set the power cord into the notch of the
power cord retainer, as shown in Figure 3-20.
(1): Rear panel
(3): Power cord retainer
Figure 3-20 Install the power cord retainer
Note:
Currently, only the S3100-TP-PWR-EI series Ethernet Switches are equipped with
an AC power cord retainer to prevent the power cord from accidentally falling off.
The location of the power cord retainer holder varies with S3100-TP-PWR-EI series
Ethernet Switches.
4) Check whether the PWR LED on the front panel of the switch is ON. If yes, the
power is properly connected.
Caution:
Before powering on the switch, you should properly connect the grounding cable.
(2)
(1)
(3)
(2): Power cord retainer holder
(4): Power cord
3-17
Chapter 3 Installation
(4)