Installation Manual
H3C S3100 Series Ethernet Switches
Power system
PoE (as powered
device)
System power
consumption (full
load)
Fan
Operating
temperature
Relative humidity
(noncondensing)
Note:
Only S3100-16C-SI DC-powered switch or S3100-8C-SI DC-powered switch
supports 100Base- TX PD interface module. Notice that S3100-16C-SI
DC-powered switch can accommodate only one PD interface module.
The PoE configuration is on the remote power source device, on the powered
device (S3100-16C-SI DC-powered switch or S3100-8C-SI DC-powered switch),
you only need to insert the cable into the interface of 100Base- TX PD.
BIDI interface card must be used in couple; that is, if the local end uses
100Base-LX-SM1310-BIDI,
100Base-LX-SM1550-BIDI.
An S3100-16C-SI or S3100-26C-SI switch can accommodate only one ONU
module (1000Base-PX10/20). For details about ONU modules, refer to section 1.7
"ONU Modules".
Item
S3100-26C-SI
Both DC-powered switch and AC-powered switch are
available to each model. The AC-powered switch supports
only AC input, and the DC-powered switch supports only DC
input.
AC input:
Rated voltage range: 100 VAC to 240 VAC, 50 Hz/60 Hz
Input voltage range: 90 VAC to 264 VAC, 47 Hz to 63 Hz
DC input:
Rated voltage range: –48 VDC to –60 VDC
Input voltage range: –36 VDC to –72 VDC
Not supported
20 W
None
0°C to 45°C (30°F to 113°F)
10% to 90%
S3100-16C-SI
Supported by
DC-powered
switch
12 W
None
the
remote
end
1-30
Chapter 1 Product Introduction
S3100-8C-SI
Supported by
DC-powered
switch
10 W
None
needs
to
use