Chapter 3 Installation; Installing A Switch; Cabinet Mounting - H3C LS-3100-16TP-EI-H3-A-O Installation Manual

Installation Manual
H3C S3100 Series Ethernet Switches
Caution:
On a mounting screw of the chassis of the H3C S3100 Series Ethernet Switches, there
is a seal labeled with H3C. You must keep it intact before asking the agent to maintain
the switch. You must get the permission of the local agent before you can open the
chassis. Otherwise, you will be responsible for irreversible damages caused by your
operations.

3.1 Installing a Switch

3.1.1 Cabinet Mounting

You can install a switch into a 19-inch standard cabinet in one of the following four
ways:
Use front mounting ears
Use front mounting ears and a tray
Use front mounting ears and rear mounting ears
Use front mounting ears and guide rails
The installation methods of a switch depend on the depth and width of the switch. For
the specific installation methods, see Table 3-1 and Table 3-2.
Table 3-1 Installation methods for a switch with a width of 440 mm or 436 mm (17.3 in.
or 17.2 in.)
Method
Depth
≤ 300 mm
(11.8 in.)
360 mm (14.2
in.)
420 mm (16.5
in.)

Chapter 3 Installation

Use front and
Use front
mounting
ears
√
—
√
—
√
—
3-1
Use front
rear mounting
mounting ears and a
ears tray
√
√
√
Chapter 3 Installation
Use front
mounting
ears and
guide rails
√
√
√