Advertisement
Quick Links
ALULINE SCREWLOC FLATPAX KITCHEN RANGE
C - Back Rail
E - Visible Side Left
HARDWARE
Screw 4.0 x 50mm
Screw 3.5 x 16mm
Plinth Leg With Base H100mm Kit
Cantenaria-profile_Silver
Clip and fix plate for cantenaria
ASSEMBLY GUIDE
BASE CABINET 150mm
F - Back
PRODUCT
Shelf Studs
B - Cantenaria Profile
TOTAL NUMBER OF PANELS: 6
QTY
10
26
2
4
1
2
1
A - Visible Side Right
G - Adjustable Shelf
D - Floor Bottom
IMAGE
Advertisement
Related Manuals for PG BISON ALULINE SCREWLOC KITCHEN BASE UNIT 150MM
Summary of Contents for PG BISON ALULINE SCREWLOC KITCHEN BASE UNIT 150MM
- Page 1 ALULINE SCREWLOC FLATPAX KITCHEN RANGE ASSEMBLY GUIDE BASE CABINET 150mm F - Back B - Cantenaria Profile C - Back Rail A - Visible Side Right G - Adjustable Shelf D - Floor Bottom E - Visible Side Left TOTAL NUMBER OF PANELS: 6 HARDWARE PRODUCT IMAGE...
-
Page 2: General Instructions
GENERAL INSTRUCTIONS 1. Confirm that all panels (6) are in the package before assembling. 2. Check the white sticker on each panel for the labelling (A, C, D, E, F & 3. Ensure that the panels are laid on a non-abrasive surface when assembling. - Page 3 STEP 1 Screw 4 x 50mm Connect panels C & D to panel A using Screw 4.0 X 50mm in the pre-drilled pilot holes as shown. Refer to Det 1 - 3 below before fastening the screws. STEP 2 Det. 1 Det.
- Page 4 STEP 3 Slide the 3mm panel (F) into the groove on panels A & E with the finished side facing down. STEP 4 Screw 3.5 x 16mm First, check the diagonal of the cabinet by measuring the two distances indicated by the broken lines.
- Page 5 STEP 5 X 12 Screw 3.5 x 16mm Plinth Leg With Base H100mm Kit Det. 4 Flip the cabinet up-side down as shown. Place the four units of Leg Adjustable Base 100mm in the shown positions, aligning with the pre-drilled pilot holes on panel D. Ensure that the orientation is as shown in Det.
- Page 6 STEP 7 Fix the cantenaria profile as shown below.Step 1; Insert the end cap flush with the profile. (View Det.5). Step 2; Use the screw provided to securely fasten the end dowel to the profile and onto the panel A and panel E. (View Det.6). Step 3; Fix the cantenaria profile to the top using the special connecting plate.(View Det.7) Cantenaria Profile Fixing plate...
- Page 7 STEP 8 Shelf Studs Insert the Shelf Studs in the shown positions. STEP 9 Det. 5 Slide in panel G as shown, such that it sits on the four shelf studs. The level of the shelf is adjustable by shifting the position of the shelf studs as shown in Det. 5. See Door Installation Guide for further instructions.
- Page 8 STEP 10 (GOLA PROFILE INSTALLATION) Brackets X Bracket X Det. 9 Using Screw 3.5 x 16mm, connect the shown Brackets X on panels A & E as shown. Use the pre- drilled pilot holes to align the brackets. See Det. 9. Bracket Y Fig.
Need help?
Do you have a question about the ALULINE SCREWLOC KITCHEN BASE UNIT 150MM and is the answer not in the manual?
Questions and answers