Ballard Designs Ann MF020 Manual

Cabinet 34”h x 15 3/8”w x 11”d

Download this manual

PRODUCT NAME: Ann Cabinet

ITEM NUMBER: MF020

ASSEMBLED DIMENSIONS : 34"H x 15 3/8"W x 11"D

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

UPDATED: 9-25-2020

Prevent accidentally discarding small parts or

hardware. Retain all carton contents until assembly

and installation are complete.

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

MADE IN VIETNAM

Page 1 of 4

Need help?

Do you have a question about the Ann MF020 and is the answer not in the manual?

Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Ann Cabinet ITEM NUMBER: MF020 ASSEMBLED DIMENSIONS : 34”H x 15 3/8”W x 11”D Prevent accidentally discarding small parts or hardware. Retain all carton contents until assembly and installation are complete. PRODUCTS ARE NOT INTENDED MADE IN VIETNAM FOR COMMERCIAL USE.
Page 2 Assemble in location for intended use. REQUIRED TOOLS: Ltr. Qty. Hardware Included Phillips Screwdriver Shelf Supports -Two person assembly suggested. Remove all parts, hardware and protective packaging from carton Wall Anchoring and carefully arrange on a clean, Anti-tip Kits level, padded surface. See Page 4 Ltr.
Page 3 STEP 1: Determine location for Shelf (D) then insert Shelf Supports (A) into corresponding pre-drilled holes. Set Shelf level upon Supports. LEVELERS: Cabinet is equipped with Rotary Levelers installed under each corner. If necessary, Cabinet may be adjusted by carefully lifting applicable corner and turning Leveler clock- wise/counterclockwise.
Page 4 WALL ANCHORING HARDWARE (ANTI-TIP) Ltr. Qty. Hardware Included Large Screw Small Screw WARNING Tip-Over Hazard Bracket Serious or fatal crushing injuries can occur from a furniture tip-over Prevent tipping accidents. Anchor your furniture. Retention Belt Installation: 1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit. 2.