Programmable Mixing - FUTABA 9VAP Instruction Manual

Four separate Programmable Mixing circuits allow almost infinite mixing combinations. The
features of this program provide the modeler with unlimited versatility in trimming and
control ing complex, high-performance models.
• Mixing of any two channels is possible.
• Four completely independent mixing circuits are available.
• Mixing amounts can be adjusted independently in either direction from neutral or offset point.
• The PROG-MIX ON/OFF Switch can be selected.
The point at which the mixing direction reverses is fully-adjustable.
•
• PROG-MIX circuits can be mixed with or "slaved" to built-in mixing functions.
• PROG-MIX circuits can be mixed with each other.
Trim corrections on the "Master" channel can be added to the slave channel or not, as desired.
•
• Bi-directional mixing can be accomplished using two mixing circuits (Ex: Flapperons)
• Adverse coupling of control inputs in fixed-wing aircraft can be eliminated. (Ex: Tendency to roll when
rudder is applied in knife-edge flight.)
Slave Channel
Master Channel
When the SET program key is pressed,
the CHANNEL SETTING screen is
displayed.
Mixing Circuit Number
PROGRAMABLE MIX

Programmable Mixing

+ and - indicate
the direction
of mixing
Circuit is usable
when set to ON
When ON, the trim inputs to the
"Master" channel are also mixed
Operation (Mixing)
to the "Slave" channel.
Amount
When OFF, trim on
the "Master" channel affects
the "Master" channel only.
Switch Mode (ON/OFF Switch Selection)
1. Always ON
2. PROG. MIX Switch
3. RUD. D/R CH9 Switch
4. 3- 8 MIX Switch
5. ELEV. D/R Switch
Indicates the control stick position
that the mixing reference
point (R/L or U/D Direction Change Point)
is offset to.