Ele-Flp - FUTABA 7CAP Instruction Manual

ELEV-FLAP mixing (ACRO):
Adjustability:
Rate: -100% (full up flap) to +100 (full down flap), with a default of +50% (one-half of the flap range is achieved
when the E S
LEVATOR
Switch: assignable, or null, so mix is always active.
GOAL of EXAMPLE:
Activate ELEV-FLAP mixing. Adjust
flap travel to 45% flaps.
Set switch assignment to null so the
mix is always active.
Where next?
ELEV-FLAP mixing is the first pre-programmed mix we'll cover. This mix makes the
flaps drop or rise whenever the E
to make tighter pylon turns or squarer corners in maneuvers. In most cases, the flaps
droop (are lowered) when up elevator is commanded.
is pulled to provide full up elevator.)
TICK
STEPS:
Open the ELEV-FLAP function.
Activate the function.
Adjust the travels as needed.
(Ex: +45%)
Optional: change S
change to NULL so flaps only respond
to E
LEVATOR
Close menu.
Adjust flaperons' flap travel available ( FLAPERON): see p. 43.
Set up AIRBRAKE: see p. 52.
Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 50.
View additional setups on the internet:
LEVATOR
control. Ex:
WITCH
S input.
TICK
49
S is moved. It is most commonly used
TICK
INPUTS:
for 1 second. (If basic,
to ELEV-FLAP .
to 45%.
to NULL. (--)
www.futaba-rc.com\faq\faq-7c.html.
again.)