Acro Basic Menu Functions - FUTABA 7CAP Instruction Manual

A LOOK AT THE RADIO'S FUNCTIONS STEP BY STEP
MODELsubmenu: includes three functions that manage model memory: MODEL SELECT, MODEL COPY and MODEL NAME.
Since these functions are all related, and are all basic features used with most models, they are together in the MODEL
submenu of the BASIC menu.
NOTE: When you choose a new model in the
MODEL SELECT function, if the new model is set to
the other modulation, you must cycle the transmitter
power to change modulations. If you do not cycle
the power, the modulation type will flash on the
home screen to remind you. You are still
transmitting on the other modulation until you affect
this change.
GOAL:
Select Model #3.
NOTE: This is one of several functions
for which the radio requires
confirmation to make a change.
Confirm proper modulation of new
model memory.
Where next?
MODEL SELECT: This function selects which of the 10 model memories in the
transmitter to set up or fly.
(Each model memory may be of a different model type from the other memories.)
STEPS:
Open BASIC menu, then open MODEL
submenu.
Choose Model #3.
Confirm your change.
Close.
If PPM or PCM are flashing in the middle of the lower side, then the new model is set
for the other receiver type. Turn the transmitter off/on to change the modulation.
NAME the model: see p. 27.
Change MODEL TYPE (aircraft, heli): see p. 28.
Change modulation [FM (PPM) or PCM]: see p. 28.
Utilize servo REVERSE: see p. 31.
Adjust END POINTs: see p. 32.
Set up TH-CUT for throttle management: see p. 33.
25
FLASHING
INPUTS:
for 1 second.
ADVANCE,
(If
if required to MODEL.
to 3.
for 1 second.
sure? displays.
again.)