Servo Reverse - FUTABA 7CAP Instruction Manual

Auxiliary channel function (CH5 and CH7): defines the relationship between the transmitter
controls and the receiver output for channels 5 and 7.
GOAL of EXAMPLE:
Change channel 5 to switch D.
Remember that if you assign primary control of a channel to a switch which you later use for other functions (like
dual/triple rates or airbrakes), every time you use that other function you will also be moving the auxiliary channel.
Servo reversing (REVERSE): changes the direction an individual servo responds to a C
For CCPM helicopters, be sure to read the section on SWASH AFR (p. 63) before reversing any servos.
Always check servo direction prior to every flight as an additional precaution to confirm proper model memory,
hook ups, and radio function.
NOTE: THR-REV is a special function that reverses the entire throttle control, including moving the trim functionality to the
Stick's upper half. To use THR-REV, turn off the transmitter, hold down the M
THR-REV and turn the D
IAL
GOAL of EXAMPLE:
Reverse the direction of the elevator
servo.
Where next?
Adjustability:
•
channels 5 and 7 may be assigned to any S
(for example, moving flaps to a switch)
•
multiple channels may be assigned to the same switch.
•
channels set to "NULL " are only controlled by mixes.
STEPS:
Open BASIC
submenu.
Go to channel 5 switch assignment.
Change to D.
Close.
Except with CCPM helicopters, always complete your servo reversing prior to any
other programming. If you use pre-built ACRO functions that control multiple servos,
such as FLAPERON or V-TAIL, it may be confusing to tell whether the servoneeds to be
reversed or a setting in the function needs to be reversed. See the instructions for each
specialized function for further details.
to REV. Turn the transmitter off and back on. This change affects all models in the radio.
STEPS:
Open REVERSE function.
Choose proper channel and set
direction. (Ex: ELE REV)
Close.
Adjust servo travel with END POINT: see p. 32.
Set up dual/triple rates and exponential (D/R,EXP): see p. 34.
Set up flight timers: see p. 37.
Set up trainer functions: see p. 38.
PARAMETER
menu then
ODE
31
(A-H) or none (null).
WITCH
INPUTS:
for 1 second.
ADVANCE,
(If
to PARAMETER.
to CH5-SW.
to D.
S motion.
ONTROL TICK
and E keys, turn on. C
ND
INPUTS:
for 1 second.
ADVANCE,
(If
to REVERSE.
to ELE.
to REV.
again.)
D to
URSOR OWN
again.)