FUTABA 4PK-2.4GHZ Instruction Manual page 49

Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direc t c all but ton
is set, the setup screen is also
called by the following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
Steering (EPA) adjustment
(Preparation)
- Before setup of the steering end point adjustment (EPA), set
the steering D/R dial (initial setup: DL1) to the maximum steer-
ing angle position 100%.
- Select the setting item "ST-LFT" by (JOG) button up or down
operation and make the following adjustments:
1
Steering (left side) adjustment
Turn the steering wheel fully to the left and
use the (+) or (-) buttons to adjust the steering
angle.
2
Steering (right side) adjustment
Turn the steering wheel fully to the right and
use the (+) or (-) buttons to adjust the steering
angle.
3
When adjusting the steering angle of another channel imme-
diately after this, see the adjustment method for that channel.
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
50
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
Press t he button
button
* b l i n k s a t t h e c u r r e n t
setup item.
End Point Adjuster "EPA"
Setting item (channel and direction)
ST-LFT :Steering (left side)
ST-RGT :Steering (right side)
TH-FWD :Throttle (foward side)
TH-BRK :Throttle (brake side)
3C-UP :3rd channel (up side)
3C-DWN :3rd channel (down side)
4C-UP :4th channel (up side)
4C-DWN :4th channel (down side)
Setting item selection
(channel and direction)
- Select by (JOG) button left or right
operation.
- The direction (ST-LFT and ST-RGT)
linked with the steering wheel is
switched.
- The direction (TH-FWD and TH-
BRK) linked with the throttle trigger
is switched.
Adjust button
Adjust with the (+) and (-) but-
tons.
- Return to the initial value "100"
by pressing the (+) and (-) but-
tons simultaneously for about 1
second.
Note
Step #1 & #2 are done when
the receiver is in the on posi-
tion installed on the chassis.
You're watching the wheel
reach their maximum end point.
Steering EPA
ST-LFT :0~120
ST-RGT :0~120
Initial value :100
100%