Advertisement
Quick Links
Advertisement
Related Manuals for Genexis FTU-300
Summary of Contents for Genexis FTU-300
- Page 1 FTU-100 FiberTwist Series Installation Guide...
- Page 2 In the box adhesive wall plugs cover splice warranty seal zip ties foam & screws screw holders Fiber Management Unit Baseplate Transparent demarcation cover (FMU) with coupler...
- Page 3 Installation guide Choose configuration • Choose one of the three ingress ports to use for the feeder fiber. • If using ingress 1, please cut out the oblong on the baseplate. If using ingress 2, the oblong is already cut out by default. •...
- Page 4 De-assemble the FTU, so that the baseplate and FMU are separated. Use the drilling template to mount the baseplate to the wall. The baseplate can also be mounted directly on a wall junction box. The drilling template is available on https://genexis.eu/product/fibertwist/downloads#ftu 60 mm 60 mm...
- Page 5 Attach pigtail or patch cable • Remove the SC/APC coupler from the FMU. • Take the protective cap off the top end of the coupler and off the fiber connector, and plug the fiber connector into the coupler. • Put the coupler and fiber back in the FMU. There is only one correct way to put the connector back in the FMU: •...
- Page 6 Attach feeder fiber • If using ingress ports 1 or 2, insert the zip ties through the appropriate set of holes. • Strip the outer sheath off the feeder fiber. • If required, install a gasblocker. The gasblocker should rest in the recess. •...
- Page 7 Splice fiber(s) • Place the appropriate splice holder. • Splice the feeder fiber and pigtail together. • Place the splice in the splice holder. • Store the overlength fiber in the FMU. • Perform any tests required to guarantee the quality of the splice.
- Page 8 WDM combiner (optional) A WDM combiner is used for terminating a network with CATV services on a separate RF-overlay fiber. Depending on the model it will be provided with a pre-installed WDM combiner. To install: • Roll out the Data and CATV fibers. •...
- Page 9 Patch-out (optional) The device supports the ability to add patch out fiber cables. Depending on the model these couplers and/or pigtails are pre-installed in the FMU. • Connect the pigtail(s) to the patch out coupler. • Splice the pigtail(s) with the feeder fiber(s). •...
- Page 10 Patch-in (optional) The device supports the ability to patch in fiber cables. These connectors are pre-installed in the FMU. • Please connect the fiber patch cable from the third-party FTU to the patch-in port of the FiberTwist FTU. Depending on the model, you need to place an SC or LC connector.
- Page 11 Finish installation • Remove the remaining protective cap from the FiberTwist coupler. • Place the FMU with the installed fibers on the baseplate. • Click the transparent cover on the baseplate and FMU. • Fasten the cover to the baseplate with the screw provided. •...
- Page 12 Revision 1.2 September 2022, Copyright © 2022 Genexis Netherlands B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the FTU-300 and is the answer not in the manual?
Questions and answers