Automatic Buttonhole; Buttonholes - ELNA 3210 Instruction Manual

1
2
3
0.5 - 1
2 - 4
33

Automatic Buttonhole

All buttonholes should use interfacing that is the same
weight as the fabric. Interfacing is especially important
when sewing on stretch fabrics. Always make a test
buttonhole on extra fabric before sewing on your fabric.
• Use a narrow stith width (4) for a finer buttonhole, a
wider stitch width(6.5) for a more substantial
buttonhole.
• Use a shorter stitch length (0.5) for finer fabrics, a
longer stitch length (1) for heavier fabrics. Remain
within the range of the buttonhole illustration.
4 6.5
1. Attach the automatic buttonhole foot. Make sure the
button opening is at the back of the foot when it is
attached.
2. Pull open the buttonholder
the button in it. Push the buttonholder together tightly
around the button.
NOTE: Placing the button in the automatic buttonhole
foot automatically sets the size of the buttonhole. The
button holder on the foot adjusts for a button up to 2.5 cm
(1") in diameter. If you are using a novelty button or
extremely thick button that does not fit through the test
buttonhole, pull the buttonholder open to lengthen the
buttonhole .
2
3. Pull the buttonhole lever
0.5 1
1
to the back and place
3
down as far as it will go.