Inserting The Bobbin; Inserting - ELNA 3210 Instruction Manual

Inserting the Bobbin

Place the bobbin in the bobbin case with the thread
running counterclockwise.
1
Guide the thread into first notch on the front side of the
bobbin case.
Hold the bobbin with your right hand and pull the thread
to the left, through the tension spring blades.
1
Continue pulling the thread lightly until the thread slips
into second notch .
2
Pull out about 15 cm (6") of thread.
2
Replace the bobbin cover plate.
Refer to the chart shown on the bobbin cover plate to
check the threading.
16