Table of Contents
Advertisement
z
q
w
x
t
c
y
v
u
e
r
e
Inserting the bobbin
CAUTION:
Turn OFF the power switch before inserting the
bobbin and threading the bobbin holder.
z Place a bobbin in the bobbin holder with the thread
running off counterclockwise as shown on the hook
cover plate.
q End of thread
w Bobbin holder
e Hook cover plate
x Hold the bobbin with your fingertip so it does not
rotate.
Guide the thread into the front notch of the bobbin
holder. Draw the thread to the left, sliding it between
the tension spring blades.
r Front notch
t Tension spring blade
c Continue to draw the thread lightly until the thread
slips into the side notch.
y Side notch
NOTE:
If the thread does not come out from the side notch,
rethread from step x.
v Pull out about 4˝ (10 cm) of thread.
Set the left edge of the hook cover plate into opening.
Push down the hook cover plate to fit in place. Check
the threading by referring to the chart shown on the
hook cover plate.
e Hook cover plate
u Thread
17
Advertisement
Table of Contents
