DTF521_Manual.fm Page 11 Tuesday, February 28, 2006 10:36 AM
LCD monitor cabling diagram
DTF-521/PL-521, rear view
The
OUT port is used to
ANALOG RGB
connect a second VGA device such as
a projector or monitor that mirrors the
pen display. Be sure to fully install the
pen display hardware and software
before connecting a projection device
to the unit. Do not connect or
disconnect any cable while the pen
display or your computer are turned
on.
C
AUTION
Use only the power adapter that came with the DTF-521/PL-521; use of an improper power
adapter may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-521/PL-521 or
your computer are turned on – this can damage the LCD monitor or computer video card.
Make sure that the display refresh rate does not exceed 70 Hz for XGA mode, or 75 Hz
for other modes.
Do not attach the USB data
cable until instructed to do so.
– B –
DC IN
(12V)
ANALOG RGB
ANALOG RGB
– A –
VGA cable
Video card
VGA port
Rear panel of your computer
Power adapter
– C –
OUT
IN
To AC outlet
Installation
page 11