Removing The Back Cover - Cisco AIR-AP1120B-A-K9 - Aironet 1100 Series Access Point Hardware Installation Manual

Chapter 4 2.4-GHz Radio Upgrade for Autonomous Access Points

Removing the Back Cover

To remove the access point's back cover, follow these steps:
Remove all cables and power connections from the access point.
Step 1
Remove all static-generating items from the work area, such as plastic material, styrofoam cups, and
Step 2
other similar items.
Place the access point and the new 2.4-GHz radio (in its antistatic bag) on an antistatic work surface.
Step 3
Step 4 Discharge any static buildup on your body by touching a grounded surface (antistatic work surface)
before proceeding.
Position the access point so that the back cover is facing up.
Step 5
The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
Caution
handling.
Remove the back-cover retaining screw using a Philips screwdriver (see
Step 6
Figure 4-1
1
Step 7 Hold the front cover with one hand, and with the other hand gently slide the back cover towards the
connector end of the unit.
Gently lift the connector end of the back cover and remove the cover.
Step 8
Go to the
OL-4309-07
Access Point Back Cover Screw
1
Back cover screw
"Removing a 2.4-GHz Radio"
2
2 Back cover
section.
Cisco Aironet 1100 Series Access Point Hardware Installation Guide

Removing the Back Cover

Figure 4-1).
4-3