Declaration Of Conformity For Rf Exposure; Guidelines For Operating Cisco Aironet Access Points And Bridges In Japan; Japanese Translation - Cisco AIR-AP1120B-A-K9 - Aironet 1100 Series Access Point Hardware Installation Manual

Declaration of Conformity for RF Exposure

Combinations of power levels and antennas resulting in a radiated power level of above 100 mW eirp are
Note
considered as not compliant with the above mentioned directive and are not allowed for use within the
European community and countries that have adopted the European R&TTE directive 1999/5/EC and/or
the CEPT recommendation Rec 70.03. For more details on legal combinations of power levels and
antennas, contact Cisco Corporate Compliance.

Declaration of Conformity for RF Exposure

The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements in CFR 47 Sections 2.1091, and 15.247 (b) (4) addressing RF Exposure from radio
frequency devices. The access point should be installed more than 20 cm from your body or nearby
persons.
Guidelines for Operating Cisco Aironet Access Points and
Bridges in Japan
This section provides guidelines for avoiding interference when operating Cisco Aironet access points
and bridges in Japan. These guidelines are provided in both Japanese and English.

Japanese Translation

Cisco Aironet 1100 Series Access Point Hardware Installation Guide
B-6
03-5549-6500
Appendix B Declarations of Conformity and Regulatory Information
OL-4309-07